Fine-Dispersed Iron (III) Oxyhydroxides Synthesis: Carbamide Precipitation
DOI:
https://doi.org/10.20535/1810-0546.2014.6.35940Keywords:
Iron oxyhydroxide, Iron (III) salt, Carbamide, Chemical precipitationAbstract
The conditions of carbamide precipitation synthesis of fine-dispersed iron (III) oxyhidroxides from iron (III) sulphate and nitrate solutions were found out. In order to determine the necessary precipitant amount potentiometric precipitation titration of iron (III) sulphate and nitrate solutions with ammonia and hydrolyzed carbamide solutions were carried out. The results of these researches are expounded. The results of the investigations of precipitates properties, which were obtained from different initial solutions and characterized by different aging time, such as the precipitates phase composition and filtration properties, were presented. It was found, that the precipitation process from iron nitrate solution has less material consumption. Obtained precipitates have nanometer dispersity and the best filtration properties (less precipitant resistivity). The properties and composition changes depended on the aging time were revealed. It was determined that the filtration, physical and chemical properties of precipitates, which were obtained from the iron nitrate solution, are almost independent of the aging time. According to the results of X-ray analysis the crystal size is about 40 nm.
References
Lin Guo et al., “Iron nanoparticles: Synthesis and applications in surface enhanced Raman scattering and electrocatalysis”, Phys. Chem. Chem. Phys., is. 9, no. 3, pp. 1661–1665, April 2001.
Бычко И.Б., Калишин Е.Ю., Стрижак П.Е. Влияние условий синтеза на размер наночастиц железа // Поверхность. – 2009. – Вип. 1(16). – С. 200–207.
Гусев А.И. Нанокристаллические материалы: методы получения и свойства. – Екатеринбург: УрО РАН, 1998. – 200 с.
J. Lodhia et al., “Development and use of iron oxide nanoparticles (Part 1): Synthesis of iron oxide nanoparticles for MRI”, Biomed. Imaging and Intervention Journal, no. 6, 2010 [Online]. Available: http://www. biij.org/2010/2/e12
Осаждение гидроксидов металлов с использованием слабых органических оснований / Ваганова Ю.В., Миролюбов В.Р., Катышев С.Ф. и др. // Вестник ЮУрГУ. – 2013. – 5, № 4. – С. 16–23.
Манн Е.В. Получение черного железоокисного пигмента с использованием карбамида // Технологія-2012: матер. міжнар. наук.-техн. конф., 6–7 квіт. 2012 р., м. Сєвєродонецьк. Ч. І / М-во освіти і науки, молоді та спорту України, Технол. ін-т Східноукр. Нац. ун-ту ім. В. Даля (м. Сєвєродонецьк) [та ін.]; Укл. Тарасов В.Ю. – Сєвєродонецьк: Технол. ін-т Східноукр. Нац. ун-ту ім. В. Даля (м. Сєвєродонецьк), 2012. – С. 98.
Шарло Г. Методы аналитической химии. Количественный анализ неорганических соединений. – М.: Химия, 1965. – 976 с.
Юсупов Р.А., Нурисламов Э.Р. Расчет кривых потенциометрического титрования солей металлов в условиях образования осадков // Хим. и комп. моделир. Бутлеровские сообщения. – 2002. – № 11. – С. 48–53.
Шабанова Н.А., Попов В.В., Саркисов П.Д. Химия и технология нанодисперсных оксидов. – М.: ИКЦ “Академкнига”, 2006. – 310 с.
Белоглазов И.Н., Голубев В.О. Основы расчета фильтрационных процессов. – М.: Изд. дом “Руда и металлы”, 2002. – 210 с.
Вассерман И.М. Химическое осаждение из растворов. – Л.: Химия, Ленинград. отдел., 1980. – 280 с.
О механизме фазовых превращений γ- и δ-FeOOH при термообработке в растворах МеOH (Ме–Na, K): модель кристаллообразующих комплексов / Мирасов В.Ш., Клещева Р.Р., Герман В.А. и др. // Вестник ЮУрГУ. – 2012. – № 34. – С. 98–106.
Downloads
Published
Issue
Section
License
Copyright (c) 2017 NTUU KPI Authors who publish with this journal agree to the following terms:- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under CC BY 4.0 that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work